JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD
JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD B.Tech III ENVIRONMENTAL ENGINEERING Previous Question Paper (September - 2021 - R16)
Answer any five questions. All questions carry equal marks.
Main
What are the basis for estimation of water demand and would you adopt suitable measure of fire fighting.
Answer
The estimation of water demand is based on several key factors: domestic water consumption (based on population and living standards), industrial demand (based on the type and size of industries), commercial and institutional demand, public utility demand (for parks, street washing, and fire fighting), and compensation for losses and waste (leakage and theft). Population forecasting methods, such as the Arithmetic Increase, Geometric Increase, or Incremental Increase methods, are used to project future demand over the design period.
For fire fighting, the demand is calculated using empirical formulas such as the Kuichling's formula, Freeman's formula, or the National Board of Fire Underwriters formula, which relate the required discharge to the population. To ensure effective fire fighting, measures include: maintaining a residual pressure in the distribution system (typically 7 to 10 meters of head), providing dedicated fire hydrants at strategic intervals, ensuring the availability of independent fire storage tanks or reservoirs, and designing the distribution pipe network to handle the high-velocity, high-pressure flow required during emergencies.
State the effects when each of the following substances exceeds the permissible limit in water: nitrates, chlorides, sulphates, fluorides and iron.
Answer
When these substances exceed permissible limits, they cause the following health and aesthetic effects:
- Nitrates: Excess concentration (typically above 45 mg/L) causes methemoglobinemia, also known as 'blue baby syndrome,' in infants, where the blood's oxygen-carrying capacity is reduced.
- Chlorides: High levels impart a salty taste to water, cause corrosion of metallic pipes and structures, and may have a laxative effect on individuals unaccustomed to high mineral content.
- Sulphates: Concentrations exceeding 250 mg/L can cause a laxative effect on human systems and contribute to the formation of hard scale in boilers and pipes.
- Fluorides: Low concentrations (below 0.5 mg/L) lead to dental caries, while concentrations exceeding 1.5 mg/L cause dental fluorosis (mottling of teeth) and, at higher levels, skeletal fluorosis, which affects bone structure.
- Iron: Excess iron causes reddish-brown staining of laundry and plumbing fixtures, imparts a bitter or metallic taste, and promotes the growth of iron bacteria, which can clog distribution systems.
Discuss the various factors which influence the water consumption in a community.
Answer
Sign in to view the complete answer paper.
Enumerate the important water-borne diseases in India and describe how, with your knowledge of various branches of science applicable to sanitary engineering you would set about to prevent the incidence of these diseases.
Answer
Sign in to view the complete answer paper.
Write a detailed note on the design and working of a continuous flow type sedimentation tank.
Answer
Sign in to view the complete answer paper.
What is break point chlorination and under what conditions is it advocated?
Answer
Sign in to view the complete answer paper.
Describe with a neat sketch the working of a rapid sand filter (gravity type). What are the advantages over the slow sand filter?
Answer
Sign in to view the complete answer paper.
Describe the procedure of lime-soda process for water softening.
Answer
Sign in to view the complete answer paper.
The difference between the level of catchment and a service reservoir is 150m and the distance between them is 48km. The reservoir were originally constructed by a single pipe line designed to carry 0.26m3/s. It was later found necessary to increase the supply to 0.36m3/s and it was decided to lay another pipe line of the same diameter along the first part of the length and cross connected. Calculate the diameter of the pipe and the length of the second pipe.
Answer
Sign in to view the complete answer paper.
Describe any one type of joint used for joining the different types of pipes with neat sketches.
Answer
Sign in to view the complete answer paper.
Discuss about estimation of storm water run off.
Answer
Sign in to view the complete answer paper.
Enumerate the various forces which may act on pressure conduits carrying water for supply to towns.
Answer
Sign in to view the complete answer paper.
Explain the construction and suitability of cast-iron pipes and concrete pipes.
Answer
Sign in to view the complete answer paper.
Explain the sludge disposal by sanitary land fill method.
Answer
Sign in to view the complete answer paper.
A grit chamber with a proportional flow weir at its outlet to be designed to handle a sewage flow from a population of 50,000 and a per capita daily consumption of water of 123 litres. Design the grit chamber.
Answer
Sign in to view the complete answer paper.
What will be the size of a sludge digester to a sewage treatment plant serving 75,000 persons?
Answer
Sign in to view the complete answer paper.