JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD
JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD B.Tech II ELECTRONIC CIRCUITS Previous Question Paper (May - 2019 - R13)
Note: This question paper contains two parts A and B. Part A is compulsory which carries 25 marks. Answer all questions in Part A. Part B consists of 5 Units. Answer any one full question from each unit. Each question carries 10 marks and may have a, b, c as sub questions.
PART- A
What is mean by distortion in amplifiers?
Answer
Distortion in an amplifier refers to any unwanted change in the output signal waveform compared to the input signal. It occurs when the amplifier's gain is not perfectly linear or when the frequency response is non-uniform, resulting in harmonic, intermodulation, or phase distortion.
List the general characteristics of Negative feedback amplifier.
Answer
- Reduction in gain.
- Increased bandwidth and improved frequency response.
- Improved input and output impedance levels.
- Reduced noise and non-linear distortion.
- Increased stability of gain against component variations.
What frequency is one octave above 5 kHz and one decade below 10 kHz?
Answer
Sign in to view the complete answer paper.
What is square wave testing?
Answer
Sign in to view the complete answer paper.
Define stable and quasi-stable states.
Answer
Sign in to view the complete answer paper.
Illustrate the transfer characteristics of negative clipper circuit.
Answer
Sign in to view the complete answer paper.
Draw the response of a RC High-Pass Circuit for Step input if time constant is low.
Answer
Sign in to view the complete answer paper.
Summarize the advantages and dis-advantages of Push-Pull Amplifier.
Answer
Sign in to view the complete answer paper.
Draw the piece-wise linear equivalent circuit of a Diode.
Answer
Sign in to view the complete answer paper.
Draw the transistor as a switch circuit diagram.
Answer
Sign in to view the complete answer paper.
PART-B
Draw the diagram of CC Amplifier and then using the exact model derive the expressions for current gain, voltage gain, input impedance and output impedance of CC Amplifier.
Answer
Sign in to view the complete answer paper.
Draw the circuits of Current series and voltage shunt feedback amplifiers and then determine the corresponding input impedance and output impedance.
Answer
Sign in to view the complete answer paper.
The input power to a device is 10,000 W at a voltage of 1000 V. The output power is 500 W and the output impedance is 20 Ω. i) Find the power gain in decibels. ii) Find the voltage gain in decibels
Answer
Sign in to view the complete answer paper.
Explain low frequency analysis of BJT amplifier by giving the corresponding equations and waveform.
Answer
Sign in to view the complete answer paper.
Determine the effect of coupling and bypass capacitors on the low frequency response of BJT Amplifier with proper equations.
Answer
Sign in to view the complete answer paper.
What is a monostable multivibrator? Explain with the help of a neat circuit diagram the principle of operation of a monostable multivibrator. Draw the waveforms at collector and base of both transistors.
Answer
Sign in to view the complete answer paper.
Give the circuits of Positive and Negative types of shunt clippers and explain their operation with the help of input and output waveforms.
Answer
Sign in to view the complete answer paper.
State and Prove the Clamping circuit theorem.
Answer
Sign in to view the complete answer paper.
Discuss the principle operation of series-fed Class-A Amplifier with the help of circuit diagram and then prove that its maximum conversion efficiency is 25%.
Answer
Sign in to view the complete answer paper.
Briefly explain the concept of Thermal Stability.
Answer
Sign in to view the complete answer paper.
Obtain the response of a High-Pass RC circuit for Square input and then derive the expression for % Tilt.
Answer
Sign in to view the complete answer paper.
When the low pass RC circuit acts as integrator? Derive its condition.
Answer
Sign in to view the complete answer paper.
Discuss in detail the Switching characteristics of transistor and define all switching times.
Answer
Sign in to view the complete answer paper.
Describe how the transistor switch behaves in saturation.
Answer
Sign in to view the complete answer paper.
Explain how diode acts as switch? Define diode forward recovery time and Reverse recovery time.
Answer
Sign in to view the complete answer paper.
Briefly comment on break down voltage consideration of Transistor.
Answer
Sign in to view the complete answer paper.