JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD

Prerequisite

Power Electronics, Electrical Machines – I, Electrical Machines – II

Course Objectives:

• To introduce the drive system and operating modes of drive and its characteristics
• To understand Speed – Torque characteristics of different motor drives by various power converter topologies
• To appreciate the motoring and braking operations of drive
• To differentiate DC and AC drives

Course Outcomes

After completion of this course the student is able to

• Identify the drawbacks of speed control of motor by conventional methods.
• Differentiate Phase controlled and chopper-controlled DC drives speed-torque characteristics merits and demerits
• Understand Ac motor drive speed–torque characteristics using different control strategies its merits and demerits
• Describe Slip power recovery schemes

UNIT - I

Control of DC Motors Introduction to Thyristor controlled Drives, Single Phase semi and fully controlled converters connected to d.c separately excited and d.c series motors – continuous current operation – output voltage and current waveforms – Speed and Torque expressions – Speed – Torque Characteristics- Problems on Converter fed d.c motors. Three phase semi and fully controlled converters connected to d.c separately excited and d.c series motors – output voltage and current waveforms – Speed and Torque expressions – Speed – Torque characteristics – Problems.

UNIT - II

Four Quadrant Operation of DC Drives Introduction to Four quadrant operation – Motoring operations, Electric Braking – Plugging, Dynamic, and Regenerative Braking operations. Four quadrant operation of D.C motors by single phase and three phase dual converters – Closed loop operation of DC motor (Block Diagram Only) Control of DC Motors By Choppers: Single quadrant, Two quadrant and four quadrant chopper fed dc separately excited and series motors – Continuous current operation – Output voltage and current wave forms – Speed and torque expressions – speed-torque characteristics – Problems on Chopper fed D.C Motors – Closed Loop operation ( Block Diagram Only)

UNIT - III

Control of Induction Motor Variable voltage characteristics-Control of Induction Motor by Ac Voltage Controllers – Waveforms – speed torque characteristics. Variable frequency characteristics-Variable frequency control of induction motor by Voltage source and current source inverter and cyclo converters- PWM control – Comparison of VSI and CSI operations – Speed torque characteristics – numerical problems on induction motor drives – Closed loop operation of induction motor drives (Block Diagram Only)

R18 B.TECH EEE III YEAR

UNIT - IV

Rotor Side Control of Induction Motor Static rotor resistance control – Slip power recovery – Static Scherbius drive – Static Kramer Drive – their performance and speed torque characteristics – advantages, applications, problems.

UNIT - V

Control of Synchronous Motors Separate control and self-control of synchronous motors – Operation of self-controlled synchronous motors by VSI, CSI and cyclo converters. Load commutated CSI fed Synchronous Motor – Operation – Waveforms – speed torque characteristics – Applications – Advantages and Numerical Problems – Closed Loop control operation of synchronous motor drives (Block Diagram Only), variable frequency control - Cyclo converter, PWM based VSI & CSI.

TEXT BOOKS:

• 1. “G K Dubey”, Fundamentals of Electric Drives, CRC Press, 2002.
• 2. “Vedam Subramanyam”, Thyristor Control of Electric drives, Tata McGraw Hill Publications, 1987.

REFERENCES:

• 1. “S K Pillai”, A First course on Electrical Drives, New Age International (P) Ltd. 2nd Edition. 1989
• 2. “P. C. Sen”, Thyristor DC Drives, Wiley-Blackwell, 1981
• 3. “B. K. Bose”, Modern Power Electronics, and AC Drives, Pearson 2015.
• 4. “R. Krishnan”, Electric motor drives - modeling, Analysis and control, Prentice Hall PTR, 2001 R18 B.TECH EEE III YEAR