JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD

Course Objectives:

• To understand basic block sets of different simulation platform used in electrical/electronic circuit design.
• To understand use and coding in different software tools used in electrical/ electronic circuit design.
• To understand the simulation of electric machines/circuits for performance analysis.

Course Outcomes

After learning the contents of this paper the student must be able to

• Develop knowledge of software packages to model and program electrical and electronics systems.
• Model different electrical and electronic systems and analyze the results.
• Articulate importance of software packages used for simulation in laboratory experimentation by analyzing the simulation results.

Course Objectives Program Outcomes

PO1 PO2 PO3 PO4 PO5 PO6 PO7 PO8 PO9 PO10 PO11 PO12 To understand basic 3 3 3 3 3 3 2 2 1 2 2 1 block sets of different simulation platform used in electrical/electronic circuit design To understand use and 3 3 3 1 1 3 1 2 1 2 2 1 coding in different software tools used in electrical/ electronic circuit design To understand the 3 3 2 1 2 3 2 1 2 1 2 3 simulation of electric machines/circuits for performance analysis

Course Outcomes Program Outcomes

PO1 PO2 PO3 PO4 PO5 PO6 PO7 PO8 PO9 PO10 PO11 PO12 Develop knowledge of 3 3 1 3 2 3 2 3 1 2 2 3 software packages to model and program electrical and electronics systems Model different 3 2 2 1 2 1 2 1 2 2 2 3 electrical and electronic systems and analyse the results Articulate importance 3 2 0 0 2 0 1 0 2 0 2 3 of software packages used for simulation in laboratory experimentation by analysing the simulation results

Students should be encouraged to use open-source software’s such as SCILAB, ORCAD, LTSPICE, Ngspice, Octave, Solve Elec, Simulide, CircuitLab, QElectroTech, Circuit Sims, DcAcLab, Every Circuit, DoCircuitsetc. for carrying out the lab simulation listed below.

Use of Professional Licensed versions of softwareslike MATLAB, LabVIEW, NI Multisim, PSpice, PowerSim, TINA etc. is also allowed.

Use of ‘Python’ platform for simulating components/ circuit behaviour.

Suggested List of Laboratory Experiments:

The following experiments need to be performed from various subject domains.

• 1. Introduction to basic block sets of simulation platforms. Basic matrix operations, Generation of standard test signals
• 2. Solving thelinear and nonlinear differential equations
• 3. Measurement of Voltage, Current and Power in DC circuits.
• 4. Verification of different network theorems with dependent and independent sources using suitable simulation tools.
• 5. Verification of performance characteristics of basic Electronic Devices using suitable simulation tools.
• 6. Analysis of series and parallel resonance circuits using suitable simulation tools
• 7. Obtaining the response of electrical network for standard test signals using suitable simulation tools.
• 8. Modeling and Analysis of Low pass and High pass Filters using suitable simulation tools
• 9. Performance analysis of DC motor using suitable simulation tools
• 10. Modeling and analysis of Equivalent circuit of transformer using suitable simulation tools.
• 11. Analysis of single-phase bridge rectifier with and without filter using suitable Simulation tools.
• 12. Modeling and Verification of Voltage Regulator using suitable simulation tools.
• 13. Modeling of transmission line using simulation tools.
• 14. Performance analysis of Solar PV model using suitable simulation tools