JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD

Prerequisite

Power Systems and Power Electronics

Course Objectives

to prepare students to

• know different terms of power quality.
• illustrate power quality issues for short and long interruptions.
• construct study of characterization of voltage sag magnitude and three phase unbalanced voltage sag.
• know the behavior of power electronics loads, induction motors, synchronous motor etc. by the power quality issues
• know mitigation of power quality problems by using VSI converters.

Course Outcomes

Upon the completion of this course, the student will be able to

• Know the severity of power quality problems in distribution system;
• Understand the concept of voltage sag transformation from up-stream (higher voltages) to down-stream (lower voltage)
• Compute the power quality improvement by using various mitigating custom power devices.

UNIT - I: INTRODUCTION

Introduction of the Power Quality (PQ) problem: Terms used in PQ - Voltage, Sag, Swell, Surges, Harmonics, over voltages, spikes, Voltage fluctuations, Transients, Interruption, overview of power quality phenomenon, Remedies to improve power quality, power quality monitoring.

UNIT - II: LONG & SHORT INTERRUPTIONS

Interruptions – Definition – Difference between failures, outage, Interruptions – causes of Long Interruptions – Origin of Interruptions – Limits for the Interruption frequency – Limits for the interruption duration – costs of Interruption – Overview of Reliability evaluation to power quality, comparison of observations and reliability evaluation. Short interruptions: definition, origin of short interruptions, basic principle, fuse saving, voltage magnitude events due to re-closing, voltage during the interruption, monitoring of short interruptions, difference between medium and low voltage systems. Multiple events, single phase tripping – voltage and current during fault period, voltage and current at post fault period, stochastic prediction of short interruptions.

UNIT - III: SINGLE-PHASE & THREE-PHASE VOLTAGE SAG CHARACTERIZATION

Voltage sag – definition, causes of voltage sag, voltage sag magnitude, and monitoring, theoretical calculation of voltage sag magnitude, voltage sag calculation in non-radial systems, meshed systems, and voltage sag duration. Three phase faults, phase angle jumps, magnitude and phase angle jumps for three phase unbalanced sags, load influence on voltage sags.

UNIT - IV: POWER QUALITY CONSIDERATIONS IN INDUSTRIAL POWER SYSTEMS

Voltage sag – equipment behavior of Power electronic loads, induction motors, synchronous motors, computers, consumer electronics, adjustable speed AC drives and its operation. Mitigation of AC Drives, adjustable speed DC drives and its operation, mitigation methods of DC drives.

R19 M. TECH. EPE/EPS

UNIT - V: MITIGATION OF INTERRUPTIONS & VOLTAGE SAGS

Overview of mitigation methods – from fault to trip, reducing the number of faults, reducing the fault clearing time changing the power system, installing mitigation equipment, improving equipment immunity, different events and mitigation methods. System equipment interface – voltage source converter, series voltage controller, shunt controller, combined shunt and series controller. Power Quality and EMC Standards: Introduction to standardization, IEC Electromagnetic compatibility standards, European voltage characteristics standards, PQ surveys.

TEXT BOOKS:

• 1. Math H J Bollen “Understanding Power Quality Problems”, IEEE Press.
• 2. R.C. Dugan, M.F. McGranaghan and H.W. Beaty, “Electric Power Systems Quality.” New York: McGraw-Hill.1996

REFERENCES:

• 1. G.T. Heydt, ‘Electric Power Quality’, 2nd Edition. (West Lafayette, IN, Stars in a Circle Publications, 1994).
• 2. Power Quality VAR Compensation in Power Systems, R. Sastry Vedam Mulukutla S.Sarma,CRC Press.
• 3. A Ghosh, G. Ledwich, Power Quality Enhancement Using Custom Power Devices. Kluwer Academic, 2002 R19 M. TECH. EPE/EPS M. TECH. I Year II Sem. (EPE/EPS)